|
|
|
|
| Step1 Lay tree on its side. Square the stand with the tree. Use a hammer to drive the stand on base of the tree. |
 |
| Step2 Tap the screw crank to imbed it into the tree. Turn crank clockwise to anchor stand securely. |
 |
| Step 3 To straighten: Push tree to correct position then just stomp on the rim. |
 |
| To Remove Stand: Push the tree over, unscrew the crank and pull off the stand. It comes off easily. |
INSTALLATION 2004 MODEL & BEYOND
The 2004 model D-8 and larger has been delevoped for tree lots only. Trees from eight feet tall to twenty feet tall. It is unbelievable until you see what it does. There is no other stand like it. The D-8 and D-10 tree stand can be installed on a tree and adjusted upright in less than a minute by your tree lot operator. The Davis Christmas tree stand with the diamond shaped wedge takes a larger hammer to drive the stand on to the base of the tree trunk.
The D-6 Davis Christmas tree stand is for stores as well as tree lots, because it can be installed with an ordinary hammer. It is used on the smaller trees from up to six feet tall weighing less than thirty pounds. Every one has a small hammer. Just drive the stand on to the base of any tree trunk and anchor it securely with the screew crank. If the tree happens to be tilted, just push it straight and stomp on the rim of the tree stand.
To remove the stand, just push the tree over, unscrew the crank and lift off the stand. It comes off easy.
There is no reason to buy an artificial tree and then have to store it for a year plus damage that good feeling about Christmas, when it so easy have a real tree. Real trees have that fresh Christmas smell and the joy of going out to pick out that special tree.
Become an active member of the Davis Christmas Tree Stand Network and let's
keep that Christmas spirit and tridition alive. Just ask your friends and your
favorite store to become an active member, too.
Home | Helpful Suggestions
Copyright© 2004 Davistreestand, All Rights Reserved.
